Beli carbide rod di monotaro.id

- Cutting diameter tolerances +0/-0.005mm.

Drill rods have a hex shank that inserts into the drill and a threaded head that accepts a matching tip. Also called drill steels, they are available in different lengths to provide the reach needed for an application.

Quality recipes, cost-effective

Cylindrical-End Cutting All sizes are nominal. Sizes marked * are 3mm shank, all others are 6mm shank. Cut Numbers: Cut 6 - Double Cut Crosscut and double cut to improve control and chipbreaks. Manufactured from high grade tungsten carbide for general-purpose use. Cut 9 - Chipbreaker Chipbreaker fast stock removal for improved control and reduced chips for use on hard materials, i.e. steel alloy 50RC, 60RC, carbon and cast iron. Suitable for deburring and polishing of cast iron, cast steel, carbon steel, alloy steel and stainless steel etc. up to HRC65 hardness. Please note: Workpiece and tools should always be steady and well supported. Carbide burrs are not suitable for 'milling' large amounts of material, they are for light stock removal at high rpm's 'LOW FEED - HIGH SPEED'. Always ensure that at least 70% of the shank length is clamped by the collet or chuck of the tool being used. Always ensure that the tool is rated to the recommended operating speed of the burr.

Produk ini juga sering disebut dengan Carbide Rotary Burr

Cylindrical Plain End. All sizes are nominal. Sizes marked * are 3mm shank, all others are 6mm shank. Cut Numbers: Cut 3 - Rapid Cut For use on softer non-ferrous and plastic materials, i.e. aluminium, fibreglass, plastics, hard rubber and zinc alloy. Cut 6 - Double Cut Crosscut and double cut to improve control and chipbreaks. Manufactured from high grade tungsten carbide for general-purpose use. Cut 9 - Chipbreaker Chipbreaker fast stock removal for improved control and reduced chips for use on hard materials, i.e. steel alloy 50RC, 60RC, carbon and cast iron.

Chrome-VanadiumST = standardfor removing broken screws andstuds with right hand thread,in plastic boxes

THREADED ROD M10X1000- Untuk Mur dan Ring M10- Diameter Badan 10MM- Panjang Keseluruhan 1.000MM/100CM (1 Meter)- Drat 1,5- Grade 5.8- Material Carbon Steel- Finishing Zinc Plated Galvanis

Dokumentasi Produk:WARRANTY MonotaRO Private Brand

-Can be used for a wide range of processing of various metals such as cutting and grinding to burr removal.

Screw-on clamp toolholder with 93deg approach angle, for positive 55deg rhombic inserts

-A tape rod can be winded up speedily.

Twist drills HSS / Ø 3.000 mm h8 / MK-1 / DIN 345 / Surface: steam tempered / Type: N / Cutting direction: right-hand / relieved cone 118°Execution: web thinning ≥ Ø 14.100 mm • relieved cone Application: alloyed/unalloyed steel and cast steel • grey cast iron, malleable and spheroidal iron • sintered powder metal, German silver and graphite